Michael's Tractors (Simplicity and Allis Chalmers Garden Tractors) Active Users: 1422 / Visits Today: 2
Highest Active Users: 1422
Michael's Tractors (Simplicity and Allis Chalmers Garden Tractors)
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
 Password:
Save Password
Forgot your Password?

 All Forums
 General Information
 The Tractor and Attachment Gallery
 thrust bearings		  New Topic  Reply to Topic
 Printer Friendly
Author Previous Topic Topic Next Topic  

Mike Dahms

USA
54 Posts
Posted - 03/20/2013 :  08:07:48  Show Profile  Visit Mike Dahms's Homepage Send Mike Dahms a Private Message  Reply with Quote
Hi all. I'm thinking about installing these bearings on the kingpins. Read somewhere there should be grooves cut into the washers to allow grease to flow into the bearing. Can anyone tell me just where this should be done and on what washers. Thanks for the help.
Mike Dahms

olcowhand

USA
5115 Posts
Posted - 03/20/2013 :  11:09:11  Show Profile  Visit olcowhand's Homepage Send olcowhand a Private Message  Reply with Quote
2 or 3 shallow "V's" on the inside hole of the top washer only. Need only be 1/16" deep or so.

Daniel in Ky -- So much to do, so little time!
Go to Top of Page
  Previous Topic Topic Next Topic  
 New Topic  Reply to Topic
 Printer Friendly
Jump To:
Michael's Tractors (Simplicity and Allis Chalmers Garden Tractors) © Michael's Tractors 2006-2019 Go To Top Of Page
This page was generated in 0.07 seconds. Snitz Forums 2000
RSS Feed 1
end of topic