Michael's Tractors (Simplicity and Allis Chalmers Garden Tractors)

Active Users: 214 / Visits Today: 214
Highest Active Users: 214

Michael's Tractors (Simplicity and Allis Chalmers Garden Tractors)

Username:	Password:
Save Password
Forgot your Password?

All Forums

Other Tractors, Attachments and other projects

Other Projects (mechanical/electrical)

Changed oil in my RV today.

Note: You must be registered in order to post a reply.
To register, click here. Registration is FREE!

Screensize:

UserName:

Password:

Format Mode:

Format:

Message:

* HTML is OFF
* Forum Code is ON

Smilies

[quote][i]Originally posted by skunkhome[/i]
[br]It almost went off without a hitch.  After opening the drain I went to my truck to get a paper towel to wipe my hand and while I was away the top pan overflowed because the drain to the holding tank could not keep up.  What a mess.  I lost 2-3 liters over the side into my crushed limestone.  Had to stop and shovel out a 5 gal bucket load of rock to clean up.   The part  I was dreading "Changing the filter" was a snap even though the filter cartridge is in a housing on top the engine.  There was almost no drips of oil.  Not messy as i had anticipated.  Changing the oil filter  requires a special 84mm wrench to remove the "cap".

[IMG]http://i1232.photobucket.com/albums/ff369/skunkhome/9d398bd5.jpg[/IMG]

It does not look like much but I have been looking for one for weeks and prices were crazy high $50-100.   I got this one from Amazon for the best price I could find $20.80.   Curiously enough it is not made to accept 3/8" square drive. Instead you have to use a 7/8" socket as there is no room to use an end wrench.  It is made  in USA.

I also managed to reset the Mercedes Assyst System.  That instructions are an open secret held by Mercedes so most people will give up and just go to the dealer to get their oil changed and system reset to the tune of $250-325.
[/quote]

Click here to attach a photo to your post

Check here to include your profile signature.

T O P I C R E V I E W
skunkhome	Posted - 09/11/2011 : 21:05:09 It almost went off without a hitch. After opening the drain I went to my truck to get a paper towel to wipe my hand and while I was away the top pan overflowed because the drain to the holding tank could not keep up. What a mess. I lost 2-3 liters over the side into my crushed limestone. Had to stop and shovel out a 5 gal bucket load of rock to clean up. The part I was dreading "Changing the filter" was a snap even though the filter cartridge is in a housing on top the engine. There was almost no drips of oil. Not messy as i had anticipated. Changing the oil filter requires a special 84mm wrench to remove the "cap". It does not look like much but I have been looking for one for weeks and prices were crazy high $50-100. I got this one from Amazon for the best price I could find $20.80. Curiously enough it is not made to accept 3/8" square drive. Instead you have to use a 7/8" socket as there is no room to use an end wrench. It is made in USA. I also managed to reset the Mercedes Assyst System. That instructions are an open secret held by Mercedes so most people will give up and just go to the dealer to get their oil changed and system reset to the tune of $250-325.
2 L A T E S T R E P L I E S (Newest First)
B-16_IC	Posted - 09/13/2011 : 23:36:42 Reminds me of the first time we changed oil in the shop's current roll-back, we found out REAL quick like the bucket wasn't big enough! An IH 466 holds a LOT of oil! Good work figuring out what they didn't want you to.
Talntedmrgreen	Posted - 09/12/2011 : 21:58:15 Fun learning new stuff...agrivating to clean up from teh lesson though =]

Michael's Tractors (Simplicity and Allis Chalmers Garden Tractors)

This page was generated in 0.02 seconds.

Snitz Forums 2000